![]() Since the Pad Tool requires a sketch in order to create a solid, a sketch with the holes placed and dimensioned will create a solid that is fully formed. Ignoring the production workflow for a moment, the workflow can be modified so that the sketch defines the piece of wood AND the holes themselves. This process can be easily replicated using the Pad Tool and other FreeCAD Part Design workbench tools. A wood worker would typically create a rectangular piece of wood, then layout the holes, and finally drill the holes. Let's consider the example of a piece of wood with several holes in it. The Pad Tool can also be used in a manner that doesn't exactly match the way that a wood worker works. Wood workers tend to work with solid pieces of wood that are rectangular in nature, and the Pad Tool can be used in this way in line with the way that a wood worker would maniupulate the piece of wood. Second length: This parameter is ONLY available when the Two dimensions pad type has been selected.The height of the pad in each direction is half the value of the dimension option Symmetric to plane: The resulting pad is created on both sides of the plane containing the sketch. ![]() The Symmetric to plane option disables the Reversed options because it is not applicable. The amount of padding on either side of the plane can be specified separately allowing non-symmetric solids to be created. Two dimensions: This option causes the Pad Tool to create a pad on both sides of the sketch.The pad will pass through any solids that it encounters before it reaches the selected face To face: This option causes the Pad Tool to create a solid from the sketch to the face that you select.The pad will pass through any solids that it encounters before the last face To last: This option causes the Pad Tool to create a solid from the sketch to the last face that it encounters.This type can be used to create a pad between two solids To first: This option causes the Pad Tool to create a solid from the sketch to the first face that it encounters.Type: This option specifies the type of pad that will be created.It can also be used to add solid features to an existing solid once the sketch is placed on a face. If you want to reproduce dimensions in a drawing, definitely use Techdraw and then apply dimensions in that workbench.The Pad Tool is used to take a sketch and convert it into a solid. The constraints are purely used internally to drive the geometry. The 'constraints' that you apply are NOT dimensions and will not appear in the drawing page (either TechDraw or Drawing workbench). One caveat Many people are confused about the purpose of the sketcher. Open the page node in the tree, select the view, and adjust the XY properties until the view appears. If you're using the older Drawing workbench, the process is about the same but the view may be being placed outside the bounds of the page. ![]() You didn't say which you're trying to use but I'll assume TechDraw:Ĥ) Insert a view of the sketch in to the drawing (toolbar or menu) The Drawing workbench is older and being replaced with TechDraw. FreeCAD has two different workbenches for producing technical drawings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |